Ashrae 62.1 users manual

Do the requirements of have a fire-resistance rating. In most climates, these low minimum airflow rates require the use of a heating coil at the air handling unit or outdoor air intake to maintain supply air temperatures since the percentage of outdoor air will be very high in the heating mode. Note that Table F-1 specifies separation distances from air with significant contaminant or odor intensity and noxious or dangerous particles. If the interior zone was supplied with a higher rate of outdoor air than required to meets its ventilation needs, return air from this zone is not Figure 6-C—System With Multiple Recirculation Paths fully saturated with contaminants and thus can be used to ventilate other zones.

Uploader: Mok
Date Added: 9 June 2013
File Size: 66.46 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 75367
Price: Free* [*Free Regsitration Required]





Hence, the zone ventilation rate, Voz, is: Table F-2, used in Equation F-1, also lists these two categories of air.

User’s Manual for IAQ Standard Published by ASHRAE | Build Up

The standard is intended prohibited throughout the building Exhaust without recirculating back into ETS-free area. In this the design process; monitoring and evaluation plans must situation, the VRP is used to also be included in the determine the design ventilation rate documentation. Other building code requirements may also A apply. This description gives considerable latitude to the designer in determining what constitutes significantly contaminated exhaust, or noxious and dangerous exhaust as listed in Table 5-A.

The left column lists those that are often common practice to include in turnover documents. It also means that paragraphs. Humidity is better controlled if the unit is allowed to cycle on calls for cooling rather than running continuously 62. avoid the intake of humid, unconditioned outdoor air. The smoke positive pressure with respect to the barrier and air barrier type of isolation is ETS area, and in compliance with the Q referred to as "passive" as opposed to the pressure requirement.

The Both procedures may be used within the most commonly referenced in building IAQP allows maual to take credit for same building.

The room is assumed to have two occupants. This includes recirculating systems. In this case, with the window rounded up to 3 hours, this occurs from noon to 2 PM hours 12—14 in the chart above. The excess air must may have more outdoor air intake than exhaust, stack and wind effects These considerations might include the leave the building, usually through can cause large regions, such as entire hazardous nature of the indoor cracks and openings in the envelope.

This is not too surprising important advantage since occupant number of laboratory and field studies given the breadth of building designs density can vary over a wide range of the amount of ventilation air and usages.

Only the critical zones are shown for brevity. Corridor, if it exists, shall be ETS-free, ETS; the challenges of ventilating of and supplied with outdoor air at the rate of 0. This concept is defined in Figure 6-A—Breathing Zone order to clarify the difference between 6-A—Bre moving air through the ventilation athing Zone system ductwork and actually getting it to where the occupants breathe.

Finding libraries that hold this item For instance, if a space is codes and HVAC design criteria. You already recently rated this item.

Please select Ok ashrrae you would like to proceed with this request anyway. This could Discharge Near diffuser location, zone air distribution only meet the requirement if it could be shown that sufficient air gets to the remote system, perhaps by Terminal mixing between the zones.

Facility managers and system characteristics may not exist to Standard This could only meet the requirement if is could be shown that sufficient air gets to the supply air remote system, perhaps by mixing between the zones.

Specific events that physical ashare to equipment must be put constructed or renovated after the in place by the team that designed and adoption of this section on November 16, What are the ventilation requirements for this room? Does this large temperature system mean the zone ventilation effectiveness, Ez, must be assumed to be 0. A While VAV systems have an infinite number of operating points, the designer only needs to be concerned with the condition that results in the highest system outdoor air intake flow rate.

If energy conservation and concerns about overcooling in interior spaces are the reasons for wanting low minimum primary airflow rates, time averaging of zone population can be used to reduce Voz values.

We analyze this space as though it had simple dry-bulb-modulating control, such as a chilled-water valve controlled by a room thermostat.

62.1 User's Manual

For dynamically based on zone and system limited to the following. For that reason, and because of their unique natures, the building ventilation requirements are elevated to five to eight 5 0. Fixed opening with airflow into ETS Area. Without range of building operating conditions. Traps with insufficient height between the inlet and outlet on draw- Figure 5-Q—Compliant Drain Pan, through systems can cause the drain to End View back-up when the fan is on, possibly causing drain pan overflow or water droplet carryover into the duct system.

This entry was posted in Educational Software. Bookmark the permalink.

1 Responses to Ashrae 62.1 users manual

  1. Megar says:

    In it something is. Now all became clear, many thanks for the help in this question.

Leave a Reply

Your email address will not be published. Required fields are marked *